BALITENSEN MKS GEN V1.4 MotherBoard 3D Printer Controller Board RAMPS Board 1.4 & Mega 2560 Mainboard with Cable for RepRap 3D Printer

May 18, 2018 - Comment

The new MKS Gen 1.2 3D Printer Controller board combines and improves the assets of the RAMPS 1.4 and Arduino Mega 2560 boards on a fantastic single board solution. The MKS Gen 1.2 solves interface connection problems between the Arduino Mega 2560 and RAMPS 1.4 boards by having both integrated into a single board. The

The new MKS Gen 1.2 3D Printer Controller board combines and improves the assets of the RAMPS 1.4 and Arduino Mega 2560 boards on a fantastic single board solution.

The MKS Gen 1.2 solves interface connection problems between the Arduino Mega 2560 and RAMPS 1.4 boards by having both integrated into a single board.

The boards supports a wide variety of Stepper Motor Drivers – most notably A4988, DRV8825 and Ice-Blue Stepper Motor drivers drive.

The MKS Gen 1.2 board uses a high quality 4-layer PCB which optimizes heat dissipation.

Firmware can use the same configuration as RAMPS 1.4.

Easy DISPLAY + SD-CARD connector – compatible pin header on board for 12864 & 2004 LCD.

6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax.

3 x 5V output, 3 x Power voltage output.

Reserve motor pulse and direction output port.

Connection Method:
A. Mount DRV8825 correctly, don’t mount reversely, or they will be burnt.
B. As for 2004LCD, connect ESP1 to ESP1, ESP2 to ESP2

Package :
1* MKS Gen V1.2 with USB Cable.

asefur mukti